Site Overlay

MINOLTA 7145 DRIVER

Check the positions of the alignment plate and the paper from the paper exit side. Now, you must remove the drum unit by pulling it gently towards you, and then remove the shaft stopper fitting of the cleaning rod. How to Install a Toner Cartridge in the Konica Minolta Laser Printer In the first step of the replacement procedure, you must take the new toner cartridge out of the protective bag, and then shake it at least 10 times in all directions. The following are included in the return to standard Select the [3. Remove the 2 stop rings [1] and the bearing [2] on this side, and remove the paper feed roller unit [4] by sliding the bearing [3] on the rear side to the rear.

Uploader: Miran
Date Added: 28 December 2017
File Size: 12.46 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 37323
Price: Free* [*Free Regsitration Required]

How is the Gold Competency Level Attained? Removing and Reinstalling the Cleaning Blade A.

Next, you must pull the developing unit out of the printer, and then open the ADU door. Remove the 2 screws [3] for each position.

Maintaining updated Konica Minolta software prevents crashes and maximizes hardware and system performance. Lift the developing unit cover [2], and remove it.

Konica Minolta 7145 Service Manual

Whenever the wire is replaced, this adjust- ment must be implemented. Konica Laser Copier Developer -Pages. This adjustment is done when RADF fails to cor- Non-sort, hole punch, 1 original, 1 copy setting ON At the home position S1: Pull the conveyance unit [1] toward you to open.

  LEXMARK OPTRA LXI DRIVER DOWNLOAD

Remove the 2 screws [1], and remove the photo sensor fastener [2]. 77145 Products come with a manufacturer warranty only.

Position in front and in rear the 2 metal scales [2] in the tray [1] as shown in the drawing. High-voltage exists around the drum unit.

Remove the developing unit.

List of parts to be replaced arbitrarily Named; arbitrarily Count timing KRDS G0 Set the 71455 value for the parts to be replaced, parts When copy count at the paper exit is completed No. Set the staple mode and make a copy. Printer cannot Printer controller abnormalities Printer controller did not respond. Do not remove caution labels.

The TDS Toner density sensor detects the toner density in the developing unit the specified period of time after the SW2 Sub power switch is turned on. Now, you must remove the drum unit by pulling it gently towards you, and then remove the shaft stopper fitting of the cleaning rod. Remove the 2 screws [1]. Remove the operating section stopper [2].

The CCD sensor generates an electric signal analog signal corresponding to the light intensity.

  945GC M7 TE DRIVER

Using the jig [1] included on the drum unit cover, rotate the drum clockwise and confirm that there are no gaps in the setting powder coat, and that the toner collection sheet and cleaning blade are smooth, etc. This website is using cookies. First copy out time A risk of electric shock exists. 71145 of respective patterns is adjusted in the fol- The following are shown on minokta image quality lowing procedure. Next, you must lift the exhausted drum up and out of the drum unit, and then unpack the replacement component.

KONICA MINOLTA SERVICE MANUAL Pdf Download.

Next, you must open the front cover of your Konica Minolta Laser Printer, kinolta then open the cover of the toner cartridge slot. Enter kinolta 47 mode. After that, you must open the conveyance unit, and then loosen the fixing screw of the drum unit. In the first step of the replacement procedure, you must open the front door of your Konica Minolta Laser Printer, and then loosen the fixing screw of the developing unit.

© 2020 All rights reserved