Site Overlay

ASUS P5LD2 VM DH USB DRIVER DOWNLOAD

You can also restart by turning the system off and then back on. Turn on the system and change the necessary BIOS settings, if any. M a n u a l – allows you to individually set overclocking parameters. The ASIC monitors the voltage levels to ensure stable supply of current for critical components. Alignment key Gold triangle mark Chapter 1:

Uploader: Fezahn
Date Added: 14 September 2010
File Size: 50.41 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 12313
Price: Free* [*Free Regsitration Required]

Pin 5 on the connector is removed to prevent incorrect cable connection when using an FDD cable with a covered Pin 5. See pages to for details.

Operating instructions ASUS P5LD2-VM DH

These limits are designed to provide reasonable protection against harmful interference in a residential installation. From the Open field, type D: If you are not sure about the voltage of the electrical outlet you are using, contact your local power company. The D r i v e r s menu appears. The BIOS automatically detects the items in this menu. The other items Advanced, Power, Boot, and Exit on the menu bar have their respective menu items.

B A Load plate 5. A configurable field is enclosed in brackets, and is highlighted when selected. All specifications are subject to change without notice.

  KABA B-NET 9107 DRIVER

Remove the onboard battery. The illustration below shows the location of the onboard LED. Secure the card to the chassis with the screw you removed earlier. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced.

Connect the blue interface into the motherboard’s IDE connector, then select one of the following modes to configure your hard disk drive s.

C – support for 4 modules inserted into the yellow and black slots as two pairs of Dualchannel memory configuration. Operation is subject to the following two conditions: It’s a community-based project which helps to repair anything. The use of shielded cables for connection of the monitor to the graphics card is required to assure compliance with FCC regulations.

P5LD2-VM DH | Motherboards | ASUS USA

Replace the system cover. Specifications and features vary by model, and all images are illustrative.

Save the BIOS file to a floppy disk, then restart the system. This motherboard provides excellent compatibility and flexibility by supporting either bit or bit architecture. Shut down and reboot the system so the BIOS can automatically reset parameter settings to default values. Products and corporate names appearing in this manual may or may not be registered trademarks or copyrights of their respective companies, and are used only for identification or explanation and to the owners’ benefit, without intent to infringe.

  LEXMARK S301 DRIVER

Installing an expansion card To install an expansion card: Refer to the BIOS screen on page These values are not user-configurable. Remove the system unit cover if your motherboard is already installed in a chassis.

Some of the navigation keys differ from one screen to another. Rear Speaker Out Center: The following item appears only when the A I O v e r c l o c k i n g item is set to [Overclock Profile]. This is in line with the ASUS vision of creating environment-friendly and recyclable products and packaging to safeguard consumers’ health while minimizing the impact on the environment.

C a b l e S e l e c t M o d e – use this mode to select the operating mode by cable connectors.

© 2020 All rights reserved